answersLogoWhite

0

The exact location of the compression release mechanism in a 17hp Briggs and Stratton engine can vary depending on the specific model and design of the engine. Typically, the compression release mechanism is located near the camshaft or valve train assembly of the engine. It may involve additional components such as springs, levers, or pins that interact with the exhaust valve to temporarily release compression during the starting process.

User Avatar

Jeffrey Tejada

Lvl 4
2y ago

What else can I help you with?

Related Questions

What is the compression of a 3hp Briggs and Stratton engine?

Briggs and Stratton does not release specific compression values. Anything above 120 psi should be just fine, around 90-100 and you're most likely due for a rebuild. A better test is a leakdown test, with can help in determining where compression is being lost.


How much compression is good on a Briggs and Stratton 5hp engine?

any where from 120 lbs to 180 lbs


How much compression is good on a Briggs and stratton 26 hp over head valve twin engine?

Briggs doesn't publish engine compression specs, but 120 is good. 100 is okay. 80 is lousy.


How much compression is good on a Briggs and Stratton 20 hp engine?

Any thing above 130 lbs


What is spark plug gap for 10 HP Briggs and Stratton engine?

Try 32 thousands, to start, depends on how much compression the engine has at this point.


What is the compression on a Briggs and stratton 11.5hp?

The compression ratio for a Briggs and Stratton 11.5 HP engine typically ranges from 8:1 to 9:1, depending on the specific model and design. This ratio indicates the relationship between the volume of the cylinder when the piston is at the bottom of its stroke versus when it is at the top. Proper compression is essential for optimal engine performance and efficiency. Always refer to the specific engine manual for exact specifications.


How much compression is good on a Briggs and stratton 15.5 hp engine?

briggs doesn't offer compression ratings for their engines. I will usually pull it 3 to 5 times and look for 90 to 120. anything less is a problem and if it doesn't hold compression there is a problem


How do you repair compression 4.5 hp Briggs stratton engine?

To repair a Briggs & Stratton 4.5 hp engine with low compression, first, perform a compression test to confirm the issue. If compression is low, check for potential causes such as worn piston rings, a damaged cylinder, or a blown head gasket. You can remove the cylinder head to inspect these components, replacing any damaged parts. Reassemble the engine, ensuring all gaskets are properly sealed, and retest the compression to verify the repair.


How much compression is good on a Briggs and Stratton 17.5 hp engine?

I just got 110 - with new rings but still doesn't run right. ...


Gap on spark plug Briggs and stratton engine 4.5?

0.030 is the gap for briggs and stratton 4.5 hp mower


Which oil filter fits a Briggs and Stratton 15HP engine?

You can get that info on the Briggs and Stratton website. Just go to: http://www.ereplacementparts.com/briggs-and-stratton-parts-c-16758.html?gclid=CPCZj4vGr58CFZdM5Qodp3bDsA and enter your engine model number.


Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?

Where is the location of the idle screw on the Briggs and Stratton 6.0 engine mulcher mower?