huh!?? retype...
pull them off. there not put on properly, dont worry its only a Daewoo Matiz.
faulty switch on gear box
open the lift-gate and take off the tail lamp
To remove the cigarette lighter in a Daewoo Matiz, first, ensure the vehicle is off and disconnect the battery for safety. Use a flathead screwdriver to carefully pry off the trim surrounding the lighter. Once exposed, gently pull the lighter out of its socket, disconnecting the wiring harness attached to it. Reassemble any trim pieces and reconnect the battery after the replacement or repair is complete.
To remove the window winder on a Daewoo Matiz, first, use a flathead screwdriver to carefully pry off the decorative cap from the winder handle. Once the cap is removed, you will see a retaining screw; unscrew it using the appropriate screwdriver. After the screw is removed, pull the winder handle off the spindle. If it’s stuck, gently wiggle it while pulling to free it.
There are four screws around where the speedo display is, and another screw inside the compartment below the radio. Having removed these, the dashboard pulls off. Fairly easy.
97 $420ec swich not off
When blower comes on the windscreen wipers are faster then slow,and cd player turns on and off any explaination available could it possibly be that you have a short or wires loose and touching?
This answer is in relation to a Matiz on a 51 plate. The surround is removed by unscrewing 4 screws around where the speedo display is situated, and another screw at the back of the compartment below the radio. after this the surround pulls off. To refit, the surround just pushes back on and replace the screws.
To turn off the airbag light on a 2000 Daewoo Matiz, you should first check for any fault codes using an OBD-II scanner, as the light may indicate an issue with the airbag system. If there are no faults, you can try disconnecting the car battery for about 15 minutes to reset the system. After reconnecting the battery, the light may turn off if there are no underlying issues. If the light remains on, it's advisable to consult a professional mechanic for further diagnosis and repair.
To fit an outside door handle on a Daewoo Matiz, first, remove the door panel by unscrewing and gently prying off any clips. Next, disconnect the linkage and wiring from the old handle. Position the new handle into the door, ensuring it aligns with the mounting holes, and secure it with the screws. Finally, reconnect any linkages or wiring and reattach the door panel.
To fit a Daewoo Matiz CV boot, first, lift the vehicle and remove the wheel to access the CV joint. Then, detach the old boot by cutting it off and clean the joint thoroughly. Apply new grease to the joint, slide the new boot over it, and secure it with clamps at both ends. Finally, reassemble any components and lower the vehicle back to the ground.