The two bolts are reachable only ewhen you remove the air filter assembly and the battery. They can be found on the back/top part of the transaxel housing. One is adjacent to a bolt that secures the transaxel housing to the engine. The upper starter bolt is just slightl to the rear of it. ayou'll need a 14mm wrench for both bolts.
It's on the transmission, two 14mm bolts.
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
The starter is located on the driver side of the under the intake maniford it has two bolts 14mm to remove it.
The cylinder head on a Toyota Paseo requires 33 pounds of torque on the head bolts. If the bolts are over tighten the block can warp leading to a blown head gasket.
The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.
The starter is located on the driver side below the intake all the way in the back. hooked up with two bolts to the transmission.
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
I believe the correct answer is 2 bolts
where are the two bolts located on the starter?
The starter is located under the intake manifold. You will have to remove the intake manifold being very careful not to drop any of the bolts into an in port. The starter is fairly easy to access once the manifold is off.
remove the neg battery cable then the wires on the starter. Then take out the mounting bolts and work the starter out.
the starter is located on the bellhousing towards the passenger side