0
Where can I get a wheel sensor connector for a Chevy 2001 cavalier?
Wiki User
∙ 14y ago
There are many of them at a salvage yard.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the front abs sensor located on a 1996 Chevy Cavalier?
it should be located right on the back of the wheel assembly
Why does trac off light come on on a 2001 Chevy cavalier?
The low trac light in your 1998 Chevy Cavalier means your vehicle has low traction. Low traction means the sensors have detected wheel spin and the engine power reduces to prevent wheel spin. You may have a bad wheel sensor.
How do you remove rear wheel bearings on a Chevy Cavalier?
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier?
Instructions on how to change the rear hub wheel bearings on a 1996 Chevy cavalier
ABS comes on on light braking almost stopped 2003 Chevy trailblazer?
Probably the wheel speed sensor. Check the connector. If connection is good then the sensor may have been damaged or it has failed.
Is a 88 Chevy Cavalier Z24 Rear wheel Drive?
No
Is a 1990 Chevy Cavalier rear wheel drive?
No sir, it is front wheel drive.
Where is the OBD2 connector on a 1996 Chevy Cavalier?
Directly under the steering wheel on the bottom of the dashboard.With the driver's door open kneel down between the door and the drivers seat. This position will allow you to easily see the OBDII connector. There is usually a plastic cap over the actual connector pins.
Does a 1984 Chevy Cavalier 4 door have front wheel drive or rear wheel drive?
Front wheel drive.
Grinding noise in front of Chevy cavalier on wheel rotation while driving straight?
Wheel bearing
How much horsepower does a 2.8L Chevy Cavalier have?
around 130 at the fly wheel
How do you remove steering wheel Chevy Cavalier?
Removing a standard steering wheel from a Chevy Cavalier requires taking off the lower steering column and horn button. The steering wheel is held on by mounting screws, after removed be sure to unplug the horn wire.
