0
What else can I help you with?
What is the torque specs on head gaskets for 1988 Toyota corolla?
torque specs on head gaskets 1988 toyota corolla 4A-F
What is the brake rotor specs for 93 Toyota corolla?
The brake rotor specs for 93 Toyota corolla the outside diameter 255 mm and inside diameter is 142.2 mm.
What is the length of a 1994 Toyota Corolla?
4.275m See http://www.cars-directory.net/specs/toyota/corolla/1994_5/2387/
How much does a Toyota Corolla weight?
Toyota Corolla does weights about (depends on a model and specs) 2,822 lbs or 1280 kilos.
Wheel bearing torque specs 2003 Toyota Corolla?
216 nm
What are the timing specs for a 1998 Toyota Corolla?
no timing spec at all due to used timing chain.
What is the torque specs of a Toyota corolla 1.3L 2E engine?
There are torque specifications for every bolt in a Toyota Corolla 1.3 L engine. The head bolt torque specifications is 70 pounds.
What is the torque specs on a Toyota corolla cam head bolts?
Look in a Haynes repair manual relative to your vehicle i do not have any manual
What are the torque specs on a Toyota Corolla 1.6 lt engine cylinder head?
The Toyota Corolla 1.6 liter engine cylinder head bolt torque specification is 150 pounds. The head bolts should be torqued in 50 pound intervals.
What is the spark plug calibration for a 2003 TOYOTA corolla?
Call any auto zone or go to their website and look up specs that should tell you
What are the cylinder head torque specs on a 1990 Toyota Corolla?
Depending on the model/engine type, the cylinder head torque specs for a 1990 Toyota Corolla are: For the 4AFE (1.6) coupe/sedan/wagon: 44 ft lbs For the 4AGE (1.6) GTS coupe: 1st: 22 ft lbs 2nd: additional 90 degrees 3rd: additional 90 degrees
What is the torque specs on head gaskets for 1997 Toyota Corolla?
The torque specs for the head bolts on a 1997 Toyota Corolla goes in three simple steps: step one- tighten the bolts in the the correct order to 22lbs step two- in the same order, turn each bolt 90 degrees step three- go through and again in the same order turn each bolt in an additional 90 degree.
