The F Connector is a coaxial RF connector used for television. You can get help installing an F connector online from the electrical section of the 'About' website.
To install a cylinder head temperature sensor on a F-250, you disconnect the cylinder head sensor from the electrical connector at the rear of the cylinder head. When installing the new one, you reverse the process of removal. The cylinder head temperature sensor is located by the O2 sensor.
F connector is a connector used for over the air transmissions.It is used for connecting set-top box on tv,cable transmissions,television transmissions and satellite transmissions.
I think it uses BNC connectors.
The UTP cable it uses an RJ-45 connector. For coaxial cable, it will be either an F connector or a BNC connector.
F-Series Coaxial Connector
The "F" connector is the most common type that is used on RG6 cable. This is the universal connector for home use of RG6 with antennas, CATV, satellite, and consumer electronics.
A thin coaxial cable that is used as a connector is also called a thinnet. It is popular in linear bus networks.
The connector you need is called a "F" connector. It can be done with hand tools but Radio Shack makes a CRIMPER and a STRIPPER for just this work.
ST is round metallic connector rather SC is square plastic connector. ST and SC connector are two types of fiber optic connectors. For 10Base-F connection, the connector is usually ST type ;For 100Base-FX usually IS SC type connector. The core of the ST connector exposed and the SC'core is inside of the connector
Passenger side firewall. Has a vaccume hose and a three wire connector.
The most common connectors for coaxial cables are F-type and BNC.
Driver side left fender about 8 inches below and left under diagnostic connector if your standing over it. Its grey.