I've had great success with Hawk Strictly Suzuki on line at http://www.hawksuzukiparts.com/
the normal / power switch only found on 4speed A/T is on the shift console. the PRNL switch is on the side of all A/T transmisions.
It changes the shift pattern of the transmission. You want to have this switch off at all times unless you are hauling some weight (i.e. a trailer). If you switch it on you will notice the transmission will delay the shift to ensure there is enough power to compensate for the added weight.
A power window relay switch relays the power from the car's battery, to the switch itself, and then to the window motor. When pressing the button inside of the car it allows the power to go from the relay switch to the motor and roll the window up or down.
If you mean the extra switch on the drivers side power window control it cuts power to the passenger side window switch. Handy if you have kids.
un push the button on the shift console. done.
Type your answer here... This switch on automatic transmission models is a power selector. When in the "N" position the transmission shifts at Normal shift points. When "P" is selected the shift points are at a higher Rpm (Power).
the switch is on the door panel approx four inches from the window, this is the only switch that sends power to the window regulator motor (window motor).
Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.Defective passenger power window switch. It is stuck in the down position. Raise the window and immediately disconnect the switch until you can replace it.
AT switchThe at switch when pushed to the right makes the transmission hesitate a few seconds before changing gears. it gives you a little more power in the gears! to the left is normal gear changing as it says (normal)
If it looks the same it will probably work.
NOTE: Anytime the battery terminal has been disconnected, please initialize the driver's door power window and front passenger's door power window after reconnecting the battery terminal. With ignition switch in the "ON" position, do the following: 1. Push down and hold the driver's door power window switch to completely open the window. 2. Pull and hold up the driver's door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination. 3. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions. At this time the power window switch for the passenger's door window should be blinking. 4. Push down and hold the passenger's door power window switch to completely open the window. 5. Pull and hold up the passenger's door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination. 6. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions
The led light in the window switch is not replaceable. It is only serviced with the entire switch.