Want this question answered?
A: the timer is no problem but the light with music is. A transformer that follows music is required to drive it as audio to lamps. Another way is optical isolator possibly audio input triacs outputs MOC3022 should do it, The timer can be motor driven or L;M555 timer
The Jenn Air Over the Range Microwave oven, has audio signals for a timer.
There isn't a device known as a 'timer' in digital audio, but there is a 'clock' or 'wordclock master'. This is a device (usually a rack-mount box) that sends a timing signal to several digital audio devices so that all the devices are working at precisely the same speed.
The timer is used to give the motor time to reach its running speed at the star voltage. Once the timer times out the star contactor drops out and the delta contactor pulls in.
Control means, a timer cant control is speed directly, it can control its operation. A times will have NO nd NC contacts. Connect the motor in series with the timer contacts wrt desired operation
its is very simple whem motor shifted on delta then timer will disconnect
The National Audio Timer, Model TE903, is an early generation digital (segmented LED display) clock/timer made in the early 1970's by Matsushita Electronics of Japan. It allows the switching on and off of a 120VAC output and was intended for use in powering hi-fi stereos which were big at the time. It was switchable for 50/60 cycles and had a European style female recepticle to provide switched voltage. A very good and accurate clock.
the important is contactor, timer, olr.....
It depends upon the type of fault and type of timer,whether electronic, motorised or pneumatic. For some faults the motor just runs in star or when switching on it just jumps into delta while for other faults nothing changes i.e. when its motor is burnt that is for motorised timer or its card is burnt that is for electronic type.
Its mounted on the washer pump/wiper motor.
Possible causes: Motor is bad (can you hear the motor run?) Belt the from the motor to pulley/drum is worn or broke Bad timer or control unit
everything is built into wiper motor including delay timer. there is a fuse you must check no relay.