The minimum thickness for a 1998 Chevy Tahoe's rotors is 30mm. Rotors must be replace when they fall below this thickness due to reduced braking power.
It is the safe and legal minimum thickness allowed for a brake rotor.
The minimum thickness on the front rotors for a 1994 Mustang Cobra?æis .97 inches. The minimum thickness on the rear rotors is .50 inches.?æ
The minimum thickness for the rotors on an 05 Chevy Equinox is between 0.6 and 0.9 inches. This is the width or thickness of the rotor measured at its thinnest point.
The minimum thickness number should be cast into the rotor.
The thickness of brake rotors are measured with a tool called a caliper. The specifications for the particular car will show the minimum thickness that a rotor can still be used.
The minimum brake rotor thickness for the front and back rotors on a 1992 Honda Accord is 21mm. Rotors which are below this thickness will not offer adequate or reliable braking.
The minimum brake rotor thickness for a 1994 Ford Thunderbird car is .974 inches for the front rotors and .657 inches for the rear rotors.
The minimum thickness for the front rotors on a 2003 Subaru Baja is 22mm. This is measured by using a caliper across the narrowest point of the rotor.
The minimum thickness for rotors on a Dodge truck is between 0.5 and 1 inch. It varies greatly based on the model and whether it is the front or rear brakes.
Minimum disc thickness vented front 24.6mm .Minimum disc thickness rear 16.6mm. min pad thickness front & rear 1mm
The minimum wear or discard thickness is cast into either the front or backside of the rotor
There is a legal minimum thickness for all rotors.
The minimum rotor thickness for the rear brakes off a 2003 Subaru Forester will depend on the build date of the vehicle:Models up to June 2003 use 266mm solid rotors. The minimum thickness is 8.5mmModels from July 2003 onwards use 290mm vented rotors. The minimum thickness is 16mm
Should be 1.024 inch
The minimum thickness for the rear rotors on a 2006 Dodge Grand Caravan is 0.44 inches. When they have worn beyond this point, they must be replaced for proper braking power.
The minimum thickness for the rotors of a 2001 Mazda B3000 is 0.5 inches for the rear and 0.97 inches for the front. Falling below this threshold can result in poor braking performance.
What is the minimum rotor thickness of the front and rear brake rotors on an '03 VW Jetta TDI?
25.3 mm 0.996 in
Not unless they are under the minimum thickness spec.
If they have enough thickness left to still be above legal minimum thickness after the resurfacing, yes.
The min thickness should be stamped on the backside of the rotor, pull and examine.
You can have your brake rotors resurface for approximately $20. The brake rotor thickness must meet minimum standards, in order for them to be resurfaced.
You need to get that vital info from a manual for that car.