0
What else can I help you with?
Where can you get a Nissan 1991 stanza body kit?
www.wickedbodies.net/90-92-Stanza.htm
Where do you add fluid to 1987 stanza transmission?
Body fluid or what? Be specific.
Can you get a body kit for a 1987 Nissan Pintara?
no
Where can I find some nice body kits for a 1992 Nissan Stanza?
i just typed in 92 Nissan stanza in Google and about three down their is one that says body kits. they only sell one its 600.00 dollars but its pretty nice I would check eBay......parts and accessories category
How do you remove the rear bumper on a 1991 Nissan Stanza?
First remove the tailights then the trim piece on the rear body pannel(where the stanza emblem is) then you will see the bolts for the bumper hope this helps.
Where is the neutral safety switch on the 1990 Nissan Stanza.?
Attached to body behing brake pedal (if automatic) clutch pedal (if standard)
What part of a wagon has the same name as a body part?
neck
Diagram of removing rear seat of 1990 Nissan Stanza?
To remove the rear seat of a 1990 Nissan Stanza, start by locating the seat bottom clips or bolts at the front edge of the seat base. Use a flathead screwdriver or wrench to release these fasteners. Next, lift the seat bottom upwards to detach it from the rear brackets. Finally, for the seat back, locate any bolts or clips securing it to the body and remove them before lifting the seat back out.
Will body parts off a 92 Nissan hard body fit a 97 Nissan hard body?
no sir.
How do you set the idle speed 1991 Nissan Stanza?
To set the idle speed on a 1991 Nissan Stanza, first ensure the engine is at normal operating temperature. Then, locate the idle speed adjustment screw on the throttle body, usually near the throttle linkage. Use a tachometer to measure the RPM while adjusting the screw until it reaches the specified idle speed, typically around 750 RPM for this model. Finally, double-check the adjustment and ensure all connections are secure before taking the vehicle for a test drive.
When Toyota stop making Camry station wagon?
In 1997 Camry and Corolla makes did not offer a wagon body style.
How do you remove and install a starter on a 1987 Nissan Stanza?
Oh yeah dude, easy. Remove the frame rails on the bottom of the car right under the starter (below the throttle body) then take off passenger side wheel, remove that from the transaxel (some working space) then remove the engine mount that is in your way. Just rip out the starter, take it to a parts shop, get a new starter and your core back =) and stick the new one in! Hope that heps!
