You can get the battery clamps for a class experiment at the store that sells school laboratory items.
First, disconnect the negative (ground) cable from the battery. Next, disconnect the positive cable from the battery. Using a socket wrench with an extension, loosen or remove the battery hold-down clamps at the bottom of the battery. There are two clamps, on opposite ends, that pinch against a ridge on the bottom of the battery. the clamps and ridge are designed to keep the battery from bouncing out of the holder as the vehicle encounters rough roads.
Assuming the battery is charged, battery cables in good condition, clamps tight on posts, and good connection at starter and ground, my guess is that the INSIDE of the battery cable clamps, and or outside of posts, need cleaning. Get a wire brush made for this at your auto supply store. Be gentle when removing the battery cable clamps. Don't pound on the battery posts or clamps when removing the clamps.You have a new battery? I have seen mechanics install new batteries and not bother to clean the inside of the cable clamps. Sears once installed two new batteries in my car before I fixed the problem myself by cleaning the inside of the clamps!I think I would start by cleaning the inside of the cable clamps.Jack
How do you take out a battery from a 95 ford econoline van
We did this experiment in class, the more batteries added, the brighter the bulb will become!
LNWR Whale Experiment Class was created in 1905.
LNWR Webb Experiment Class was created in 1882.
Either:-Your new battery is badYour new battery has not been fully charged before installationYour battery terminal clamps are not tightYour battery terminals/clamps are corroded and may need cleaning/replacementYour battery cables are faultyIf all of the above is not the case then you have an electrical problem.
undo the clamps and take it out. DO NOT MIX UP WHICH SIDE IT IS!!! if u do and u put the clamps on the wrong side, it will explode and acid with get all over u. scarring u for life. seriously. red is positive black is negative..the battery of course. read the battery to get it right
disconnect the wires that connect to the battery marked either in black and red or a - and +, then if there any clamps where the battery is sitting unscrew those as well. Then reverse order to put new battery in
porn
no a class experiment
I'm going to work on a experiment, for science class.