I had this problem before on a ranger you have to pull the dash board out and it will be right there.
How to change dash lights on a 95 Ford Ranger?
How do your remove the dashboard on a 2000 Ford Ranger?
4x4 dash lights not working 94 ranger
A 1994 Ford Ranger is OBD I / EEC IV and has an EEC TEST connection in the engine compartment by the power distribution box In 1996 , the Ford Ranger changed from OBD I / EEC IV to OBD II / EEC V and has a Data Link Connector in the dash , below the steering wheel , covered by a small removable plastic panel
The 2004 Ford Ranger OBD 2 port is under dash below or left of steering column
fuse box or heater box depends what side of dash
In my 94 ranger ext cab, it's under the dash on driver's side
Bad dash ground.
On a 2001 Ford Ranger : If you have selected 4X4 HIGH , yes , you should see (4WD in your dash ) If you have selected 4X4 LOW , yes , you should see (4WD LOW in your dash )
Most under dash driver's side. There isn't an OBD port on a 1986 ranger!!
On a 1998 Ford Ranger : Open the drivers door and in the drivers end of the dash you will see the removable plastic fuse panel cover
on the ford ranger pickup truck, it is under the passenger side dash
For a 1999 Ford ranger : ( # 17 ) is a 25 amp fuse for the cigarette lighter ( in the fuse panel in the drivers side end of the dash )
under the dash on the drivers side.
Yes, it will be under the dash on the driver side.
On a 1997 Ford Ranger : Open the drivers door , and IN the end of the dash you will see a removable plastic fuse panel cover ( the fuses are behind the cover )
you need whole harness and dash and a few dollars to add on topso as to to swap a 2.3l for a 4.0 in a 93 ford ranger.
On my 1995 Ford Explorer if the switch has been tripped so that no power is going to the electric fuel pump , the fuel reset light comes on in the gauge cluster in the dash
A blown fuse or the headlight switch could be at fault ,also possibly a broken wire in the light switch wiring.
Behind the center of the dash on the brace.
possible rollover senser under dash!
Under the dash to the left of the steering column.
underneath the dash to the left of the steering column
The OBDII connection is under the dash, near the steering column.