0
What else can I help you with?
What size wrench is needed to remove the caliper mounting bolts on 1991 caprice?
Most likely a 3/8 Allen, but 15 mm wrench is possible.
What tools needed to change front brake pads 1991 Chevrolet caprice?
To change the brake pads on a 1991 Chevrolet Caprice, you will need some tools. You're going to need a c-clamp, a hex key or Allen wrench to remove the calipers, and a wrench to bleed the lines.
How do you take off the hub cap on a 1987 Chevy Celebrity?
To remove the standard wheel cover stick the pry end of the lug wrench behind the outer edge of the wheel cover and simply pry it off. If your car has the wire wheel covers use the special wrench that comes with them to pry the center cap off then remove the retainer nut to remove the wire wheel cover.
How do you remove the plastic lug nut covers on a Chrysler 300?
Just twist them off. DON'T do this with an impact wrench.
Is there a special tool for the Titan oil filter?
No, any filter wrench will remove the filter.
Is there a special wrench to remove oil filter from 2008 dodge sprinter diesel?
YesYes
Does the oil filter for a 2000 Chevy cavalier need a special wrench?
No..maybe a oil filter wrench to remove it, but, install it by hand (HAND TIGHT)
How do I remove the fan clutch on a 1998 Jeep Grand Cherokee?
It takes a special wrench and it turns to the left to tighten and the right to loosen. You may be able to rent the wrench from Autozone.
How do you remove the starter on a 1990 Audi 100 Is there a special tool to remove the bolt?
No special tool but the inner bolt is somewhat hidden behind the solenoid. Just use an extension bar on your rachet wrench.
How do you get the nut off of the top shock in the front of a 91 caprice?
Try using a wrench.
How do you release the pressure on the fuel filter of your 87 Caprice Classic?
the 87 caprice should have a carb. which does not have a electric fuel pump there will be no pressure when you remove the line. you will need aq 5/8 line wrench and a 1 inch wrench. when you remove the fitting from the carb make sure you reinstall the plastic "o"ring gasket it will leak with out it. if the gasket is not on the fitting stick your finger in the hole and remove it .the gasket fits into a grove on the thread end of the fitting.remove the line from the fitting first the 1 inch wrench is for the carb fitting. put the new filter in with the rubber valve fecing you. good luck its not a hard job at all.
Replacing heater core 1993 caprice classic?
To replace your heater core on a 1993 caprice, you will need a screwdriver, a socket wrench, and a weather seal adhesive.
