answersLogoWhite

0

Where do i insert the oil on a 350?

User Avatar

Anonymous

16y ago
Updated: 8/17/2019

One of the two rocker covers should have a cap that can be removed for adding oil.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where does the oil dipstick tube insert on a 1973 Chevy 350 engine?

It goes into a hole on the driver's side of the block between #5 and #7. There is an indentation in the head casting to make room for it.


What kind of oil does a 350 take?

Excuse Me a 350 what??


Will a swap from a 305 to a 350 cause lower oil pressure?

No it will not. Unless the oil pressure is low on the 350 engine. If you had good oil pressure in the 305, and the 350 don't then there is something wrong with the 350. Bad oil pump, engine bearings worn out, Oil pump pick-up screen stoped up. Things like that cause low oil pressure.


What size oil filter for a 5.7L small block 350?

if its the bigger oil filter, its an stp S5. If its the smaller oil filter, its an S3986. some 350's have big oil filters, some have small


Where is the oil pressure switch on 91 silverado 350?

The oil pressure on 91 Silverado 350 is at the rear of the engine on the driver's side, This unit is usually found above the oil filter.Ê


Is there an oil pump gasket for a Chevy 350?

no


What kind of oil do you use in a 1995 Chevy 350 engine?

5W30 oil.


Will an oil base from a 78 350 gm fit a 74 350 gm?

Yes, There the same.


Where do you install the oil pressure gauge on a Chevy 350 small block?

how to install the oil pressure gauge on a Chevy 350 small block


How much oil does a 1976 Chevy 350 hold?

1976 Chevy 350 engine should take 5 qts engine oil with filter change.


Where are the oil rings on a 87 350 Chevrolet engine?

The stock 350 pistons have 3 ring grooves.The BOTTOM ring groove is for the oil ring assembly.


What type of oil does a warrior 350 take?

10w 40 wet clutch oil.