Hydraulic oil sight gauge and filler cap are located on back side of tractor below the big red warning triangle. Sight gauge is a small round window.
Do not run without hydraulic fluid, it services the transmission too !!
where do u put hydraulic fluid in a Massey Ferguson 275
in back of the shop dont want the boss catching you messing around now do you
On the left side of the gear shifters
thru the dipstick and vent hole by your bucket levers
finger it
from back of tractor right side below cab in front of rear axle a small dip stick is located.
There is a spout on the rear close to under the seat. See picture
To the left of the gear shift lever, large plug on top of transmission. Fill here,
Right side of engine right past the cab if it has one.
The dipstick for the hydraulic fluid is hard to see straight on. If you stand behind the tractor and look behind the right arm of the three point hitch you will see a yellow dipstick. The dipstick is scored on either side to indicate min and max levels,
to the left of the gear lever is a cap with a 1 1/16 bolt head on it. remove that cap and fill there. To check the level the is a small dipstick under the lift on the frame.
There is a cap right next to the gear shifters. It's about 1-3/4" dia or so with a hex head on top. The hydraulics share the same fluid as the transmission.