answersLogoWhite

0

Where do you find a nipple connector bar?

Updated: 8/18/2019
User Avatar

Wiki User

14y ago

Best Answer

Check the related link below

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where do you find a nipple connector bar?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you use nipple bars as tongue bars?

Yes, as long as the gauge is correct for the tongue piercing - for example : nipple bar is 14 gauge - usual tongue piercing jewellery is 14 gauge and the length of the nipple bar is the correct length for the wearers tongue (this varies from person to person). Basically - if it fits - wear it!


What is use of pipe nipple?

Pipe nipple is use as connector to both pipe which have female end. It does not same as pipe reducer which nipple has same diameter throughout both end and threaded. Pipe reducer has different diameter for both end and it is use to join different pipe diameter.


Do nipple stimulators arouse women?

yes many women find nipple stimulation arousing sexually.


Can you get your Nipple piercing with a barbell?

Yes you can, but this depends on the piercer in question, it is simpler to do the initial piercing with a ring but some prefer barbells i recommend that a ptfe bar is used tho as they bend to suit your nipple


Where is the Low pressure service connector on 1997 Audi?

I read on a diff site, that suggested there isnt one.. and that you unscrew the sensor and thread in a filling nipple.


How do you measure a nipple bar?

Well a nipple barbell is measured from inside the first ball on the shaft to the other ball inside on the shaft. It's the inside measurement you need not including the thread on balls. In a nipple (male of female) the barbell should be 2~3 millimeters longer than the actual nipple is across to ensure there is room for cleaning and enhancement. The nipple will become larger in diameter as the piercing heals, this applies to both female and male nipple piercings.


How do you remove a bar type nipple ring?

Simply unscrew the ball off of either side of the barbell and remove the jewellery.


Where can I find a custom connector for my Xbox?

You can find a custom connector for you Xbox at several online sites. Your best bet is ebay.com or amazon.com!


Why does my car cut out when i step on the gas when trying to start.?

you need to disconnect the two wire spout connector shorting bar located between the battery and data link connector


97 Ford Explorer leaking power steering fluid from where?

possibly from the lower connection, mine had a tiny stress split on the lower nipple that goes in to small line. I thought it was a loose connection to this line. Be careful because my nipple/connector broke clean off when i tried to remove line to find the leak. These reservoirs are hard to replace/find, maybe the junk yard. Luckily ford explorer so common this should notbe to hard to locate, good luck.


Where is PCV on Mazda B3000?

At the back of the engine compartment, on the driver's side, you will see an elbow pipe. It has a short connector hose that fits directly onto the PCV Valve nipple.


Does a 1965 CJ5 jeep have a fuse box?

No the 65 cj5doesn't a fuse box. But under the dash just to the right of center on the firewall there is a fuse bar . My 65 has a fuse bar that only has four fuses , but below this bar is a wire connector bar that has a double row of screws ten on top and ten directly below the top row that is it. I would assume that it would depending on what type of accessories your jeep came with on how long or big the fuse buss and wire connector bar is.