0
The EGR valve is located on the top of the intake manifold rearward of the throttle crank under the cowl. If you suspect a problem with the system, you may want to check the EGR control solenoid, the EGR control backpressure transducer and all vacuum hoses.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can you run a 96 mercury villager without a catalytic converter?
No.No.
Where is the carburetor on the 96 Mercury villager?
Your engine is fuel injected , so there is no carburetor
What fluid in power steering on 96 Mercury Villager?
Motorcraft MERCON ATF
How much does a cam sensor on a 96 mercury villager cost?
The cam sensor on a 1996 Mercury Villager cost about $35 to $40. The sensor is actually manufactured by a Nissan subsidiary.
Where is the location of the modulator valve on 96 mercury villager?
The 1996 Mercury Villager modulator valve can be found on the firewall in the engine compartment. The modulator valve will be on the passenger side of the firewall.
Were is the alternator located on a 96 mercury villager ls?
Front bottom of engine under the A/C compressor.
Does a 96 mercury villager have two thermostats?
No, only one thermostat. It does have two temperature sensors though.
Are 93 and 96 mercury villager interchangeable?
These vehicles are very similar and virtually all parts interchange.
How do you replace fuel pump 96 mercury villager?
The fuel pump is in the tank, and the tank will have to be removed to access it.
What direction does the thermost go in a 96 mercury villager?
The copper pellet opposite the spring end goes into the engine.
Where is the kick panel on 96 mercury villager?
The kick panels are the things next to your feet on the outside of the car when you are sitting in the front seat.
Where is blower motor fan resistor on 96 mercury villager?
Under the dash, at the extreme right near the passenger kick panel.
