If its a 2.2L, its located behind coil packs. 4 bolts hold it all together on block. as for wiring,it has 3 plug ins
Where is the ignition control module located in my 1992 Crown Victoria
Under the coilpacks
how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder
Where is the elctrical part behind the igtion at on my 1992 honda accord
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
It should be on your drivers side fender, right next to your coil.
most chryslers have the module inside the computer
Its on the firewall side of engine between transmission and engine just below the ignition coil packs one of the wire connectors from ignition module go to crankshaft position sensor
The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.
The problem is most likely a faulty blower control module.
Many autopart stores have a machine to test it. The machines use a universal adapter to hook into the ignition control module. The ignition control module is in the distributor. If you mean the part that contains the ignition coil, when mine went bad I probed it with an ohmeter and then asked the parts store if I could test the resistances in a new coil before I bought it. Since the resistances of certain terminals weren't even close, I knew I had a bad coil.