The intake would be the large aluminum housing that U'll first view after raising the hood.It sits directly on the top-middle of the engine.
Find the top radiator hose and follow it back to the thermostat housing, which should be located towards the fron of the engine on the intake manifold.
The IAT sensor on a 2004 Dodge Neon is on the intake manifold. It is inside the number two intake runner.
where can I find the egr valve on a 2001 dodge intrepid 3.5 liter
it's in the intake plenium, in the rear center. Its black plastic and has a hose attached to it that goes into the valve cover.
A Dodge Intrepid has never been offered with a 4 cylinder engine.
If you know where the intake manifold is, you will find the thermostat housing under it after taking the manifold off. You could also follow the upper radiator hose to your thermostat housing.
The EGR valve on a Dodge Neon is located on the intake manifold. You will find the EGR valve by removing the air intake plenum, the air filter, the air filter housing, and flex hose that leads from the housing to the throttle valve.
To locate the IAT sensor in a 2005 Dodge RAM 1500, you will first need to shut off the vehicle and apply the parking brake. Find your intake manifold and identify the two intake runners. The second runner will be located a few inches from the front of the intake manifold on the left side. The IAT sensor is located inside of this runner.
You need to remove the plenium intake manifod,I have a 1997,thats how i did it.
You can find a diagram of an intake manifold for a Kia Sportage at major auto parts stores. You can also find it in repair books at the library.
The intake manifold is underneath the plastic silver cover held down by four nuts. Take it off and you'll find the intake manifold - also plastic. Even more unusual, the starter is underneath the intake manifold!
It's under the intake manifold.