answersLogoWhite
Oxygen Sensors
Buick LeSabre
Pontiac Grand Am

Where do you find the sensor box on a 1987 Buick LeSabre and how can you tell which sensor is bad?

404142

Top Answer
User Avatar
Wiki User
2004-08-18 10:46:19
2004-08-18 10:46:19

I don't know what you are calling a sensor box. If you are refering to the computer, go to auto zone and have the codes read free. GoodluckJoe

1

Related Questions

User Avatar

Where do you find starter relay for 99 buick lesabre custom

User Avatar

Amazingkeys.com has the 2000 Buick LeSabre Key. It does have the chip in it.

User Avatar

its behind the harmonic balancer attached by two bolts but you must first take off the balancer to get to it

User Avatar

You can find the heater wiring diagram for a 1989 Buick LeSabre in the vehicle's owner's manual. You can also obtain it from various auto part stores.

User Avatar

Should be at the end of the upper radiator hose.

User Avatar

The Buick LeSabre doesn't have horns or antlers. Search hard and you'll never find 'em.

User Avatar

If the engine is 3.8L SFI OHV the Knock sensor is located under hood, passenger side, front engine area, below exhaust manifold, mounted in engine block

User Avatar

check under car at the passenger rear door .

User Avatar

A fuse diagram for a 1992 Buick LeSabre is available from several auto part store chains. These stores have access to online automotive databases that store troubleshooting and repair information for most vehicles.

User Avatar

Most GM fuel filters are under the vehicle, behind the driver.

User Avatar

remove the rear seat and send someone small with a flashlight in to find them

User Avatar

Call your local Buick dealership and ask them if they can order one for you. If they can't, then try going online to see if you can order one.

User Avatar

If you can't find drain plug, just disconnect lower radiator hose.

User Avatar

Somewhere on the engine. Just find a good point that is away from the belts.

User Avatar

It should be in the black box in the trunk on the passenger side where the jack and lug wrench are

User Avatar

You move the tensioner's arm with a breaker bar. The map for the belt is usually glued to the radiator support, or underneath the hood. The schematic for a 1999 Buick LeSabre fan belt routing is in Section 6 page 66 of the owners manual.

User Avatar

It is important to have a diagram to help guide changes being made in a car. A vacuum line diagram for a 1981 Lesabre can be found in its maintenance manual.

User Avatar

i can't find the iat sensor for my 1987 nissan 300zx non turbo

User Avatar

First, you should read the manual to find out how to replace it and what products can be used. If this does not help, contact the manufacturer.

User Avatar

it is under the rear seat on the drivers side. should take a 20 amp fuse.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.