Should be 2 screws. One toward the top, near the motor and one on bottom, near the prop. Open both to drain. Fill from bottom until it reaches top screw hole. Boat/ outdoor shops will have the proper oil and pump to use.
Use the recommended OIL. Do once a year. Dispense properly.
If the horsepower of your Mercury outboard lower unit is 75 and below, SAE 80W90 Gear Lube is recommended.
How do I remove the lower unit from my 1984 50 hp. Mercury outboard motor?
Never mind I figured it out
The 1973 model, 7.5 hp Mercury outboard, requires 6.8 oz. of gear oil.
No
Take it to a marine repair shop or google it up, the answer is there
It is a speedometer pick up tube.no longer used due to clogging.
Mercury® Marine High-Performance Gear Lube from Basspro
undo t 5 bolts, remove lower unit, remove pump cover, slide old impeller off & replace with new one. Mske sure wesr plates & gaskets are good & replaced in correct order. put a little grease on top of unit & that's it.
pwd 40
first of all what oil your are talking about , i hope not engine oil because there is non that is two stroke engine. lower unit has a draining bolt on the bottom and air or fill bolt on the top of the lower unit....
yes