Want this question answered?
I would not recommend that you try. A block heater is preferred.
block heater on a ford actually is not a block heater, the hater is in the right side near rear end of oil cooler on left side of engine, if you follow the plug in cord back, you will find it. it is NOT in the block
The Dodge Sprinter did not come out until 2002. The heater is an add on option that is installed in a freeze plug on the passenger side of the block.
Locate the block heater. Drain out the coolant from the rad and from the block if there is a drain there. There should be a screw in the center of the block heater. Unscrew it to loosen the block heater internal clamp. Use a pair of pliers and wiggle it free. As long as it is not plugged in, there should be no worry of damage. It is sealed with an o-ring.The element will have to be worked out as it goes into the block along the side.
the block heater takes the place of your freeze plug, in this case you would need to locate and remove the correct freeze plug and replace it with the block heater plug, plug in the cord and route to appropriate location, done
Block heaters are not installed by the manufacturer. So, unless a prior owner installed one, you do not have a block heater. If you do, it will have a standard 120 volt AC plug hanging somewhere.
I have a 95 villager and it came from the factory with a block heater.Look around the headlights for the plug tucked away.
The Toyota Camry block heater is located on the front of the engine block. You can follow the block heater cord to the block heater.
A block heater is not standard equipment.A block heater is not standard equipment.
Remove and engine block expansion plug. Insert the block heater. Seal the block heater. Attached the wiring harness to the block heater.
The 2002 PT Cruiser block heater is located on the front of the engine block. You should be able to follow the block heater cord to the block heater.
The Pontiac G6 block heater is located on the right hand side of the engine. The block heater can be located by following the block heater cord.