1982-1994 Chevy Cavaliers

Where do you put freone for air condition in a 1989 Chevy Cavalier?

123

Top Answer
User Avatar
Wiki User
Answered
2009-05-18 13:52:48
2009-05-18 13:52:48

I have a 1989 Chevy Cavalier, and I need to know how to put freon in to use the air conditioner in my Cavalier. Right now it is blowing hot air, would like cold air. Please help me.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


Make sure the 1989 Chevrolet Cavalier horn fuse is in working condition. Make sure the positive and ground wires on the horn are tight and free of corrosion.


The 1989 Chevy Cavalier dashboard speakers measure 4.5 inches in diameter. There will be a speaker on each side of the dashboard.


No. But if you mean do they have ABS, no.


The 1989 Chevy Cavalier could be either a 2.0L 4-cylinder or a 2.8L V-6.


Yes, I have a 1988 and 1989 Chevy Cavalier Z24 and they both have the 2.8L V6



Listed on the driver's door post.



A 1989 Chevy Cavalier will not stay running after it has started if the spark plugs are fouled, the fuel filter is dirty, or it has a vacuum leak. Taking the vehicle to a local mechanic or dealership can pinpoint the problem.


It is located by the ignition switch on the right side of the steering column.


on the rear exhaust manifold hard to get to


Solenoid? Is it not actually on the starter motor?


interested in any info. on 1989 cavaliers on mods. or ways to work on them .



The ECM will be programmed to shut it down around 105 mph.


The firing order for a 1989 Chevrolet Cavalier is 1, 3, 4, 2. This is for a 2.2 Liter engine.


Check the heater core in the 1989 Cavalier for leaks, as this is a common place. If the core is ok, then spray the vehicle at a car wash around all windows to find the source of the leak.



If the Cadillac is a Cimmaron, then yes. The Cimarron and Cavalier are mostly the same car mechanically. Otherwise, no.


Drain the water from your 1989 Chevy Cavalier cooling system. Remove the water return hose from the water pump. Remove the water pump belt. Remove the water pump retaining bolts. Reverse the process to install the new water pump.


has to be replaced, its on the bottom up the washer fluid jug.


Unplug the harness at the motor , then disconnect te hydrolic lines.



mine came with Goodyear Eagles, size P215/60R/14


send e-mail address to auto5starz@hotmail.con & I'll send it! Bruce



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.