answersLogoWhite

0

Well, if its motor oil you're talking about. You should see a cap on one of the valve covers (usually on the driverside valve cover). Take the cap off and pour in. The valve covers sit on cylinder heads. Hope this helps.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How to stop an oil leak?

put in a thicker oil if its the motor but if its trans. change oil and change the seal on the peace that you remove to take the oil out.


Where to Put oil in 84 Ford Tempo trans-axle?

Auto, or 5 speed ?


How do you put in transmission fluid in 06 five hundred?

needs just a quart of trans oil but don't know where to put it


Where do you put oil into a 1981 Lincoln Mark VI engine?

In the engine.


Do you put 2stroke engine oil and regular oil in a 50cc Yamaha dirt bike?

yes 2 stroke in the bottle on the handle bars and oil in the trans.


Where is the oil sending unit on a 4.9 1981 turbo Trans Am located?

look on the back of the engine on the drivers side just in back of the distributor.


What oil do you put in your 1998 Jeep Wrangler Transfer Case?

Mopar ATF+4 trans fluid


What will cause a 2001 Ford Expedition transmission to not run when put into drive?

Check your trans oil. It may be low...


What is the best year for a Pontiac trans am?

1981


What type oil do you put back in standard trans 5 sd 1998 Chavy S 10?

Gear lube


How do you put fork oil in front fork for a 1981 Yamaha 750 virogo?

you apply oil to the suspension area and then push it up and down to work the oil in.


On a 1990 gmc suburban with a 350 motor how do you replace the flywheel?

Easiest to remove drive shaft to rear (4X4 remove front one also) Remove torqe converter bolts. Disconnectcooler lines from right side of trans. Put floor jack under trans. remove cross member. Then remove trans bolts from around bellhousing. Block engine up under oil pan. Take engine weight off trans then put trans back away from motor until you can get air wrench on fly wheel bolts. After changed put back together. Be care Full and put boards under oil pans to prvent damage.