0
Where do you put the multimeter leads when you test a Molex connector?
Wiki User
∙ 14y ago
Put the black lead into any of the black connectors on the molex.
put the read lead into the yellow, or red lead on the molex.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Parts of a digital multimeter?
1 x Digital multimeter with LCD Display (the body or main unit) 2 x test leads with attached probes (sometimes removable) - 1 x black negative probe - 1 x red positive probe
How do you test polarity with a multimeter?
A: To begin with the leads polarity of the meter must be ascertain. Assuming the red is positive voltage then that lead will have a positive potential to check a diode connect the red lead to the anode and the black to the cathode and it should read some Resistance
How many test leads are needed to find resistance?
The test equipment needs two test leads to find the resistance in a circuit.
What are the types of multi tester?
A Multimeter is an electronic instrument, every electronic technician and engineer’s widely used piece of test equipment. A multimeter is mainly used to measure the three basic electrical characteristics of voltage, current, and resistance. There are two types of multimeters: Analog Multimeter: The Analog Multimeter or VOM (Volt-Ohm-Milliammeter) is constructed using a moving coil meter and a pointer to indicate the reading on the scale. Digital Multimeter: We mostly used a multimeter is a digital multimeter (DMM). The DMM performs all functions from AC to DC other than analog. It has two probes positive and negative indicated with black and red color as shown in the figure. there are some best multimeters for HVAC.
What are the basic test instruments in electricity?
A "multimeter" to test resistances, voltages, amperages. An external "clamp" meter to measure high ac currents. A "mega" meter to test insulation.
What tool is designed to test dc current from a molex connector?
The tool designed specifically to test DC current from a Molex connector is called a Power Supply Tester.
How can you test a battery?
You can test a battery by using multimeter. Set the multimeter to the DC voltmeter setting and then place the leads of the multimeter across the leads of the battery. the multimeter will have a readout of the voltage.
Where could one purchase some Multimeter Test Leads?
Multimeter test leads can be purchased at specialty stores like Radio Shack or some larger hardware stores. They can also be found online at Amazon and eBay.
What are the black and red things hanging off a multimeter?
They are called test leads, you would use them to connect the multimeter to the points that are to be tested.
How do you test ohm for speaker?
Use a multimeter or digital multimeter and set it to the ohmmeter mode. Put the test leads on the speaker terminals. It won't be perfect, but if it says 1.8 ohms or so then it's a 2 ohm speaker.
Is it possible to test a diode with multimeter?
Yes it is possible to test a diode with a multimeter.
How do you test an abs sensor?
To test an abs sensor for a Lexus ES you will need to use a multimeter. The multimeter will determine if the abs sensor works or not.
Parts of a digital multimeter?
1 x Digital multimeter with LCD Display (the body or main unit) 2 x test leads with attached probes (sometimes removable) - 1 x black negative probe - 1 x red positive probe
Why does your 120 outlet measure 49 volts when you test it with a multimeter?
Either the supply or the multimeter is faulty.
What is the purpose of an automotive multimeter?
An automotive multimeter, like any multimeter, can be used to test the voltage or current in some kind of circuit. As it is an automotive multimeter it is aimed more towards the used in a car.
How do you test a battery in a Motorola cell phone?
Take the battery out and test it with a multimeter.
How do you test a ballast resistor?
ohm the resister with a multimeter
