answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2013-08-12 01:28:09
2013-08-12 01:28:09

The Chrysler Cirrus was only built from 1995-2000. The washer bottle is under the hood on the driver side.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Under the hood, driver side, near the base of the windshield.


It goes into the reservoir that is on the far driver side under the hood. It is located close to the bottom of the windshield.


You have to refill it through the trans dipstick tube.




that will not do any damge just syphon out what you can and refill with windshield washer fluid at least the fluid will not freeze in the washer lines,lol


You put the transmission fluid into the dipstick where you check it, do it with the engine on, and on a level suface


There is no rear fluid reservoir. The fluid is pumped from the reservoir under the hood that feeds the windshield washers.



You take the cap off of the master cylinder and pour it in.


To refill your windshield washer fluid, you must locate the dispenser under the hood of your car. Near the oil, there should be another cap that has a picture of a windshield on it.


get reservior heated , unplug hoses from squirters, add rubbing alcohol to tank and flush, refill with -40 windshield antifreeze.


You need to refill the container with windshield fluid. If you do so, the light will go off.


Total transmission capacity is almost nine quarts.


drain all coolant then flush. refill with anti-freeze


I'd push the washer button until it was empty and then refill it.


It is on the bottom of the washer fluid reservoir.


Open the cap on the reservoir and pour it in.


The pump is attached to the bottom of the washer fluid bottle.


The washer fluid pump is on the bottom of the washer fluid reservoir.


On a 2000 Mercury Cougar the windshield washer fluid reservoir is at the front of the engine compartment , near the passenger side headlight


its against the firewall under the windshield fluid reservoir


You add the fluid ( ATF+4 ) down the dipstick tube. Check the fluid level at idle in Park.


Open your hood and find the windshield wiper fluid tank and drain it. The pump is located on the side of the fluid tank and is plugged in. Remove the plug and the pump output first. Pull the windshield washer fluid pump out of the tank and replace it with the new one. Hook the electric connection and the pump output and refill your fluid tank.


Firstly, check your owners manual for the exact location of the windshield washer container. Add the recommened type of wahser.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.