Condenser coil
The negative side of the coil is connected to the breaker points and condenser. The posotive side comes from the ignition switch. And the center terminal is connected to the center terminal of the distributor cap. ID REPLACE IT WITH A HEI MUCH BETTER THEN A POINTS SYSTEM.AND IT ONLY HAS ONE POWER WIRE TO HOOK UP.
Depends on the manufacturer and which coil (the evaporator or the condenser).
This motor has no distributor. It has a coil pack for each spark plug. There is no condenser.
Calculate condenser and coils
Hook it to the negative side of the coil.
The rating is technically a minimum. You could use a larger coil and have it work. But if its a Evaporator coil it will need to be matched on the far end with a similar or larger condenser coil. If the Condenser coil is larger it will probably just take a little more refrigerant.
You would hook to the negative side of the coil. Some HEI distributor caps are marked "tach".
The condenser coil, sometimes coils depending on the model, rests outside of the refrigerator compartment. Refrigerant, in a gas form and very warm, travels to the condenser coil where it cools and condenses into a liquid form as it moves through each pass of the coil. Once in a liquid state, the refrigerant is stored in a reservoir until needed for the refrigeration cycle to begin again.
Check the coil, rotor, condenser, distributor cap, and coil wire.
yes
How much does a company charges to clean a condenser and evaporator coil