0
What else can I help you with?
Replace Washer line on the 1998 Oldsmobile intrigue?
Do you mean "how do I replace washer line"? They are just rubber hose from the washer fluid container to the wipers. If you have a leak, you can get a plastic splice and put it in at the split to repair.
How do you make a rubber band powered engine?
To make a rubber band-powered engine, you'll need a few simple materials like a rubber band, a lightweight body (like a wooden stick or cardboard), and a propeller or axle. First, attach one end of the rubber band to the body and the other end to the propeller or axle. Then, twist the propeller to store energy in the rubber band. When released, the stored energy will turn the propeller, propelling the engine forward.
Where is the PCV valve on a 6 cylinder 1981 Oldsmobile Omega?
being a 3.8 buick engine it is behind said carb in the intake when replacing it replace rubber grommet as well
What causes white smoke when you start Oldsmobile intrigue?
I had this problem for 2 yrs before I found out that the PCV valve grommets were bad and had holes in there. I'm guessing that you are also burning alot of oil fast too. Check the pcv valve rubber fittings. Good luck
How do you build a Rubberband propelled car?
To build a rubber band propelled car, you will need a chassis (can be made of wood or lightweight plastic), wheels, rubber bands, a propeller (can be made of a straw or a wooden dowel), and something to wind up the rubber band like an axle. Attach the wheels to the chassis, wind up the rubber band around the axle, and attach the propeller. When you release the rubber band, it will unwind and propel the car forward.
What does a front engine mount look like?
Engine and transmission mounts are made of a heavy rubber and are usually black in color. On either side of the rubber is a way to attach it, one side to the motor or transmission and the other to a part of the cars frame. They allow the engine and transmission to vibrate without causing the whole car to shake. A front engine mount would be on a car with frontwheel drive ( sideways facing motor ) attaching it to the front of the frame in the engine compartment.
What washers or gaskets needed for rear spoiler on 2002 Olds intrigue?
For the rear spoiler on a 2002 Oldsmobile Intrigue, you typically need rubber washers or grommets to create a seal and prevent water intrusion. Additionally, flat washers may be used with the mounting bolts to distribute the load evenly. It's best to check the specific installation manual or consult with an auto parts store for exact specifications and part numbers to ensure compatibility.
How do you make a slingshot?
To make a slingshot, you will need a Y-shaped stick, rubber bands, and a pouch made of fabric or leather. Attach the rubber bands to the forked ends of the stick and tie them securely. Then, attach the pouch to the rubber bands. Your slingshot is now ready to use. Remember to be cautious and responsible when using it.
What are rubber-engine aeroplanes?
they are small planes which are powered by rubber bands
Where does rubber hose on rear differential attach on 1999 ford explorer?
It is a vent for the rear diff. Attach it high up anywhere so water can't get into it.
Why do you smell burning rubber in your 1995 Oldsmobile 98?
You may have an oil leak that is dripping onto the exhaust.
How do i make rubber basketball earrings?
Get a basketball and a shrink machine then use glue to attach to ear
