answersLogoWhite

0

I believe that goes to the center of the distributor cap

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What voltage is the hot wire to the coil on a 1985 s10 blazer 2.8?

12 volt.


Where is the coil wire located on a 1997 Chrysler Sebring LXI 2.5L?

The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.


Is coil a type of wire?

yes coil is a type of wire


How do you check compressor windings?

If you are talking about the compressor clutch coil windings then connect one wire to from the coil to ground and the other wire to a 12-volt source, the coil will become magnetized and will be able to put up a heavy piece of metal or you can use a ohm meter as well..........


Which wire goes to the coil on a Honda nsr125 1998?

The coil wire.


Which is the exhaust and which is the ignition coil on 1985 Nissan 200sx maunual 2.0 liter?

there is no such thing as an exhaust coil. the ignition coil is the cylinder shaped thing that has a spark plug wire running to the center of the distributor cap


Where is location of coil wires 8N ford tractor?

The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.


Where is the coil wire on a 1995 Buick Riviera?

There is no coil wire. There is a coil pack and connected to the coil pack is the ignition control module.


What would cause the coil wire to burn out at the coil end of the coil wire on my 93 Toyota Camry?

Toyota Camry coil wire can burn out from age or excessive use. The manufacturer recommends that you change the coil wire every 30,000 miles.


Moving a magnet in and out of a coil of wire produces an?

electric current in the coil of wire.


1985 Chevy small block 305 no spark to the ignition coil?

Ignition coil is bad, is it right on top of the cap maybe a bad wire in the wirng harness or bad connector.


Where is the ignition coil located on a 95 Honda Accord 2.2 4-cylinder?

If you see no center coil wire connector then the coil is mounted inside the distributor. If there is a center coil wire connecter then follow the coil wire and it will go to the coil.