0
What else can I help you with?
1970 Chevy big block where on dist cap is number one?
Standing in front of the car, looking at the distributor like a clock, between 3, and 5 oclock position.
Where is camshaft position sensor located on 97 suzuki sidekick?
At the back of the engine, looks like a distributor!
What is 6 o'clock position?
The term "6 o'clock position" typically refers to a specific point in a circular or clock-like layout, indicating the bottom point, directly downward. In various contexts, such as in navigation or military terminology, it helps describe the direction or location of an object relative to a reference point. For example, if someone says an object is at the "6 o'clock position," it means it is directly behind the observer or facing downwards from their perspective.
Why is 12 pm called noon?
Because the sun is at its midday high point in the sky, like the 12:00 on the clock. But at 12:00 midnight the moon is at its middle high point in the sky, like the 12:00 on the clock, before it starts going down.
Where is the crankshaft position sensor on a 97 Honda CRV?
The CKP looks like a small gear with long teeth located inside the distributor housing. If the CKP fails, unfortunately you must replace the entire distributor housing.
Where is 1 on the distributor cap 240 ci ford 6 cylinder?
I would assume that the # 1 position on the distributor cap faces AWAY from the engine like it does on other sizes of Ford straight 6 cylinder engines
What is point gap on 1976 360 dodge engine?
0.035 inch was a previous answer. I would seriously verify that. I show 0.035" as the SPARK GAP of the spark plugs, not the point gap inside the distributor. The point gap I found was more like 0.017" measured with the points open on the high lobe of the distributor shaft.
Where is camshaft position sensor 1999 pathfinder?
I would like to know where the cam sensor is on a 1999 pathfinder and is there one or they calling it a crank shaft sensor The cam shaft position sensor is located in the distributor.
Why 1996 vortec won't start after reinstallion of distributor?
As long as you marked or took note on what position the distributor cap was in when you took out the distributor, you can turn the distributor gear 180 degrees and reinstall it. There is a flat piece in the end of the distributor that looks like a flat head screwdriver and sometimes that turns when you take the whole thing out. This would put you 180 off on your timing. Try that and then reinstall and that may be your only problem.
Where is the Camshaft position sensor on 1998 Dodge Dakota 3.9L?
It is inside the distributor, it has three wires running to it, and it looks like a small black plate.
What is a simile of a clock?
'his heart ticks like a clock' or 'the clock beats like a heart'
Firing order of distributor cap on ford 1991 5.0?
1 - 5 - 4 - 2 - 6 - 3 - 7 - 8 ( if it isn't a high output - like in the Mustang ) The distributor rotor turns COUNTERCLOCKWISE The marked # 1 position on the distributor cap faces to the REAR and slightly towards the drivers side
