Want this question answered?
Overloading the circuit, short in the wiring, or incorrect fuse installed which is too small for the circuit. Always use the correct size fuse.
This circuit needed to have a fuse installed before the circuit was energized. Now the circuit is going to need new wiring along with a fuse before the system is re energized.
Circuit overloaded, short in the wiring, or the wrong size fuse is being installed and it is too small.
A circuit breaker/fuse is designed to protect the wiring from getting overloaded.
NO! The circuit wiring is protected by that 3.15 amp fuse. Put a 5 amp fuse in the circuit and the wiring may overheat and cause a fire. Never over-fuse any circuit even in an emergency.
If a fuse in your home keeps blowing it can be caused by several things. Most often it is because that circuit is being overloaded. There is simply too many things pulling power on that circuit. It can also be caused by a short in the wiring somewhere. Can also be an appliance is defective. Can also be someone has installed a fuse that is too small for the circuit. Whatever you do, do not install a larger fuse than the circuit calls for to prevent it from blowing. The fuse is there to protect the wiring from overheating and catching on fire.
The fuse in a plug is designed to blow and cut off the current in a circuit before the rest of the wiring and components are damaged or burnt-out should a short-circuit occur.
The fuse is blowing because the circuit is overloaded, there is a short in the wiring, or the fuse is too small. Be sure you use exactly the size fuse that was installed at the factory. A larger fuse may not blow but it also may cause a fire.
Short in circuit wiring or circuit overloaded.
The fuse you use is determined by the load on the circuit and the size wiring used in that circuit not the battery voltage.
A circuit breaker, or a fuse.
To prevent an overload or short from causing the wiring in the circuit supplying power to the appliance from overheating and possibly catching on fire. The fuse is there to protect the wiring and not what is plugged into that circuit.