On all three engines it is next to the thermostat housing.
Where is coil located on a 1989 dodge dynasty at
It looks like a1989 dodge dynasty! Go to your browser search, and type in pictures of 1989 Dodge dynasty and you will see what a 1989 Dodge dynasty looks like.
turn it on
A 1989 5.9L Cummins does not have a cam sensor.
The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.
its you MAP Sensor I had The same problem and i replaced the map censor and it runs fine now. it only cost me $58.00
It is located just above the oil filter (located in front of engine under exhaust manifold)
A Dynasty would have an a413 or an a604.
In a 1989 Dodge Dynasty, the speed sensor is typically located on the transmission. It is often positioned near the output shaft of the transmission, where it can monitor the rotational speed and send this information to the vehicle's electronic control unit (ECU). To access it, you may need to raise the vehicle and remove any obstructing components. Always consult the vehicle's service manual for specific details and diagrams.
5w30 or 10w30
I believe it's 104.3"
You will known when the fuel pump is working on the 1989 Dodge Dynasty because the engine will get fuel from the fuel tank. If the fuel pump is not working, the motor will be unable to idle or run.