answersLogoWhite

0


Best Answer

The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.

User Avatar

Wiki User

โˆ™ 2011-09-21 01:11:56
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is Ignition coil 96 Chrysler sebring?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the ignition coil on a 96 civic cx hatchback?

The ignition coil is inside the ignition distributor.


Can you use a front bumper from a 96' Mitsubishi eclipse or Chysler sebring for my 96' Dodge avenger?

You can use the front bumper for a 1996 Chrysler Sebring on a 1996 Dodge Avenger.


50 dollar car you want to remove the factory alarm on a 96 chrysler sebring?

It can not be removed or disabled.


Where is the ignition control module located on a 96 Chrysler Sebring Coupe LXI?

depends on eng size. The distributor contains the coils and module 3.0 and 2.5 if bad the whole dist needs replaced not servicable


What wire grounding out would make the starter ignition fuel fuse blow on a 96 Chrysler sebring jxi convertable?

check engine wiring harness where it runs across top of transmission for rubing and short to ground


Were is the heater coil located at in a 96 Chrysler cirrus?

It is inside the HVAC housing under the dash.


Does a 96 sebring v6 engiine have a non interference engine?

No, the 1996 Chrysler Sebring V-6 is an interference engine. The cam belt must be replaced every 60,000 miles.


What causes squeaky breaks on a 96 Chrysler Sebring?

If it's rear brakes there drums. Mine have made noise since it was new. Only when you first start up. I have a 96


Where is the ignition coil on a 96 dodge ram 5.2 liter van?

front passenger side of engine block


96 dodge Dakota engine codes 12 43 55 help?

ignition coil circuit failure


Where is the ignition control module located on a 96 Mitsubishi eclipse gst turbo?

It's right behind the fuel trim beside your ignition coil pack


Why would your 96 Chrysler sebring convertible stumble after you have changed the plugs and wires and cap?

you have 2of the plug wires on the wrong plugs or distributor cap

People also asked