0
What else can I help you with?
Where 1988 Nissan Pulsar fuel filter?
i have no clue
Where is the starter on a 1987 Nissan Pulsar NX?
" The Pulsar starter is located centrally, underneath the engine close to the passenger compartment." According to my car, the E16i engine, it is on the drivers side of the engine below/behind the distributor.
Where is the starter on Nissan Pulsar FN15?
The starter motor is located next to the oil filter, maybe the best way to get to it is from below
Do you have to remove the trans when you replace an engine on a 1988 Nissan Pulsar?
no u do not
How do you replace the starter on a 1992 Nissan Pulsar?
To replace the starter on a 1992 Nissan Pulsar, first disconnect the negative battery terminal to prevent electrical shock. Then, locate the starter, which is typically found on the engine's transmission side, and remove the bolts securing it in place. Disconnect the electrical connections from the starter, and then remove the old starter. Install the new starter by reversing the process, ensuring all connections are secure before reconnecting the battery.
How do you change a starter on a 1988 Toyota Cressida?
Change a starter on a 1988 Toyota Cressida
Where is the location of crank shaft position sensor on a Nissan Pulsar N16 2000 model?
Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?
Fuel pump relay location Lincoln Mark VII 1988?
where is the starter relay located on a 1990 Lincoln mark 7
Where is the starter located on an 1988 Isuzu I-Mark?
On a 1988 Isuzu I-Mark, the starter is located on the lower side of the engine, near the transmission. It is positioned towards the front of the vehicle, typically on the driver's side. To access it, you may need to lift the vehicle and remove any underbody protection or components obstructing the starter's location.
1987 Nissan Pulsar fuel pump location?
in the fuel tank
Does the 1988 Nissan Pulsar se have two separate front windshield wiper motors?
No
What is the location of a cps on a 1988 Mercedes 190e 2.3?
crank position sensor is between oil filter and starter, follow wire from module
