hey mate, pcv valve on a vr v6 (not sure about v8) is at the front of the intake manifold just to the left of the alternator and right of the thermostat housing. there's a bolt (i think its like a 17mm or a 19mm or something like that) that you have to undo and wa-la, the pcv valve is right there (you may have to get some long nose pliers to get it out as it gets stuck in there pretty tight)
Holden VR Commodore was created in 1993.
VR has hydraulic adjusters, should not need setting. If it is rattling check oil pressure and look for weak lifters.
Horn pad malfunction. Birdcage
I think you open it up and change it. Like it is so obver.
A 1994 VR Commodore thermostat housing is located where the at the end of the large lower radiator hose. There will be a small housing with two screws. Be sure to drain the coolant before attempting to remove the thermostat.
Get the mechanic to do it
65 litres
yes
The Holden VR Commodore is a large saloon car produced in the mid 1990s manufactured by General Motors - Holden Limited in Australia. They also produced a Utility vehicle.
which one? front, rear, side?
Yes but it depends if its got an airbag or not. No air bag sweet. Airbag problems.
Spectre VR happened in 1994.