fallow the upper radeater hose to the engine the hose is clampt to a housing its the thermostate houseing its just the other side of the of that --bronco2in follow the upper radiater hose to the engine the hose is clampt to the therm. housing take the housing off and u will be looking right at it -bronco2in-
!987 Bronco II had egr system, but 88's dont have egr system. I own and 88 and a manual and it states this
i beleave the inertia switch is located behind the glove box or just below it.. that's where it is located on my 86 and my old 88 bronco II
now I'm not quite sure about bronco II's but in my 93 bronco the box was located under the driver side of the dash more towards the middle. The box is about 2 x 2 1/2 inches, and has a 7 prong connector I hope this helps
The vehicle speed sensor is located at the rear differential on a 1998 Bronco II. This also serves as the ABS sensor.Ê
Where is fuel filter on 1988 bronco II?" HOW TO CHANGE IT ---- It is located underneath the car, driver side area.
push in on the turn signal...
how to replace a thermostat on a bronco 198511
check computer and odbI codes !
I BELIEVE the 2.9 liter V6 engine in a 1988 Ford Bronco II is rated at ( 140 horsepower from the factory )
The '84-'88 Bronco ll came with a 23 gal. gas tank. The '89-'90 with a 15 gal. tank.
You need to replace your fuel pump
You need to replace your fuel pump