how to replace a thermostat on a bronco 198511
First, remove the thermostat housing. Then grab the thermostat by hand and remove it.
To replace the heater core of a 1985 Bronco 2, open the glove box and push on the 2 tabs that hold it in place. After removing the entire glove box, remove the round plastic screws of the heater core. Remove the old and replace with a new one.
It is at the engine end of the upper rad hose. Remove the housing and there it is. When replacing it make sure the spring goes toward the engine/
its located on the passager side of the truck under the dash
Buy a new car to replace the faulty thermostat Follow the top radiator hose to the motor. The thermostat is in the housing that the hose is attached to and held by two bolts. Use a new gasket and sealant on fitting the housing.
To replace the thermostat in a 1985 Ford Tempo, start by ensuring the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then locate the thermostat housing, which is typically at the end of the upper radiator hose. Remove the housing bolts, take out the old thermostat, and clean the mating surfaces. Install the new thermostat with the correct orientation, reattach the housing, refill the coolant, and reconnect the battery.
Under the water manifold attached the upper radiator hose.
Where is the fuel pump located on a 1985 jeep cherokee
23 gallon all Bronco II's are
I have an '89 Bronco XLT, it has a 25 gallon tank
Should be in a removable housing at the engine end of the upper radiator hose
Look at the engine end of the upper radiator hose in a removable housing