Mercury

Where is bank 2 sensor 1 located on a 1998 Mercury Mystique?

141516

Top Answer
User Avatar
Wiki User
2008-08-01 04:41:48
2008-08-01 04:41:48

Bank 1 is the bank with No. 1 cylinder which is the firewall side and toward the passenger side, so bank 2 is toward the radiator. Sensor 1 or upstream is the highest one. You don't need the special slotted socket for this job but you need small hands to undo the pigtail.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

right behind the air filter toward the engine

User Avatar

were is the iac locate on a 1999 mercury mystique

User Avatar

the library should have a shop manual for this vehicle, you can make copies of the right sections :)

User Avatar

on the back of the block behind the intake

User Avatar

whats the wireing diagram for a 1998 mercury mystique.

User Avatar

According to the 1998 Mercury Mystique Owner Guide : ( 61.5 litres / 16.2 U.S. gallons )

User Avatar

The fuel pump fuse for a 1998 Mercury Mystique is located in the main fuse panel near the hood release. It prevents the fuel circuit from being overloading and damaging the pump.

User Avatar

A speed sensor on a 1998 Mercury Tracer is located on the transmission housing of the vehicle. It is placed on top in a secure location to safely measure the speed the transaxle spins.

User Avatar

You can view the 1998 Mercury Mystique owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides ( The fuse section starts on page 109 ) The owners manual shows the location and diagram

User Avatar

Replacing ERG Valves in a 1998 Mercury Mystique is fairly hard because it requires great precision to avoid blocking the EGR passage.

User Avatar

back of the engine in the middle at the top of the block

User Avatar

A 1998 Mercury Mystique with the 4-cylinder 2.0 DOHC appears to have a non-interference engine. Therefore, if the timing belt breaks, there should be no damage to the valves/pistons.

User Avatar

In a 1998 Mercury Villager, the mass air flow sensor is located in the air intake tube. The air intake tube goes from the air box to the intake.

User Avatar

O2 sensors are always located on the exhaust system.

User Avatar

on my 1999 ford mercury villager its on top of transmission under the van

User Avatar

There could be several reasons why a 1998 Mercury Mystique is overheating. The radiator may have a leak, the thermostat may be stuck, or the head gaskets could be blown.

User Avatar

it's complicated,you need a professional mechanic

User Avatar

The oil filter on a 1998 Mercury Mystique is changed by lifting the vehicle up on ramps, placing a drain pan under the filter, and unscrewing it. A new filter is then put in place and torqued down.

User Avatar

A 1998 Mercury Mystique , 2.5 liter V6 has : ( 1 timing CHAIN to each cylinder head , so there are 2 timing CHAINS )

User Avatar

There should be six signal lights on the mystique, two front, to rear, and two sidemarker lights.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.