Where is blower resistor on a 2000 blazer Chevy?

Ain't no fixin it, you have to replace it with a new one.

how to change the blower motor

Should be near or attached to the blower motor

resistor for fan blower is in back of glove box, beside the blower itself.

How do you set the timing on a 2000 Chevy blazer (V6)

Yes. I own a 2000 Chevy Blazer.

First locate the resistor, it is under the hood, on the firewall, passenger side, close to the blower motor. Unplug the wire connection and remove the three small screws holding it in place, then remove the resistor.

An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.

Its probably a bad resistor.

Yes, a 2000 GMC Jimmy hood is compatible to a 2000 Chevy Blazer. This is only on the S10 Blazer though.

There is a removeable panel below the glovebox. It is in front of the blower motor against the firewall. It has a wire connector from the loom and then it plugs into the blower motor

Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck

Your Blower resistor is located on your firewall under the hood. It is located on the same side as your glove box, just not immediately behind it. it is right beside your blower motor. You also have to cut away the factory rubber covering on the part. I just used an ordinary knife. After that all you need to do is unscrew the old resistor and replace. It's pretty basic when you know where it is. Hopefully you haven't taken your dash apart yet.

The blower is controlled by the blower switch, blower resistor, and relevant power relay.

how do you replace seatbelt retractor on a 2000 chevy blazer

The 2000 Chevy Trail Blazer doesn't have a timing belt.

Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.

NO it will not. They are complete DIFFERENT designs. Will NOT interchange.

No it will not work, Is it not the same.

Have your blower motor resistor or blower motor checked out

right next to the blower unit.

the 1996 and 1997 are the same and would not work in your 2000 straight from GM

The blower is located under the the passenger side dash. The resistor should be on the left side of the housing.

A 2000 Chevy Blazer is a GM vehicle. Vehicles made by GM do not come equipped with an inertia switch.

Check for a bad blower resistor at blower motor