Should be behind the glove box.
The blower motor speed resistor is located under the hood, on the firewall, passenger side, close to the blower motor.
Ain't no fixin it, you have to replace it with a new one.
how to change the blower motor
resistor for fan blower is in back of glove box, beside the blower itself.
First locate the resistor, it is under the hood, on the firewall, passenger side, close to the blower motor. Unplug the wire connection and remove the three small screws holding it in place, then remove the resistor.
Its probably a bad resistor.
How do you set the timing on a 2000 Chevy blazer (V6)
Yes. I own a 2000 Chevy Blazer.
Your Blower resistor is located on your firewall under the hood. It is located on the same side as your glove box, just not immediately behind it. it is right beside your blower motor. You also have to cut away the factory rubber covering on the part. I just used an ordinary knife. After that all you need to do is unscrew the old resistor and replace. It's pretty basic when you know where it is. Hopefully you haven't taken your dash apart yet.
There is a removeable panel below the glovebox. It is in front of the blower motor against the firewall. It has a wire connector from the loom and then it plugs into the blower motor
An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.
Yes, a 2000 GMC Jimmy hood is compatible to a 2000 Chevy Blazer. This is only on the S10 Blazer though.
heat not working