0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the camshaft sensor on 1993 Chevy lumina euro?
There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!
How do you replace a cam sensor on a 1990 lumina 3.1?
There is no cam sensor on a 90 3.1. Only a crank sensor.
How do you test the cam sensor on a 93 Nissan altima?
it has a distributer, no cam sensor
Where is the camshaft sensor located at in a 93 Chevy lumina 3.1 engine?
There is not a camshaft sensor on the '93 3.1 Lumina, just a crank sensor on the back side of the engine between the block and the barrel of the transaxle. Easy enough to get to from underneath the car.
Where is the cam sensor on a 1996 Chevy Lumina?
under neath the power stearing pump.
Does a 93 Chevy Z34 have a cam position sensor?
Yes it does.
Is there a crank sensor on a 93 suburban?
NO. A crank sensor are cam sensor was not introduced until the year 1996.
Where is cam position sensor located on 1993 Chevy lumina?
Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.
Where is the idle control sensor on a 93 Chevrolet lumina?
its on the throttle body just above the throttle position sensor (t.p.s)
Where is cam sensor on 1992 lumina apv 3.8?
The cam sensor is mounted into the front timing cover just behind or near the water pump. Note that failure of the cam sensor to work properly is usually not cause by a faulty cam sensor but more commonly a failed permanent magnet located in the cam drive gear.
Were is oxygen sensor on a 93 Chevy Lumina?
Back side of the engine....mounted in the exhaust manifold.
93 eagle talon will not start. has no sparks?
if it has no spark and no gas its your cam angle sensor
