Behind the glove compartment or behind the passenger side kick panel.
its inside the distributor.
AnswerThe ECM is usually located under the glove box.
Should be found in the passenger side kick panel area.
It located as you are looking at the engine to the left of the tbi on a mounting bracket on top of the bracket it has a four wire connector connecting to the module
I believe in 93 they had the newer style computer, this eliminated the electronic spark control module.
The ignition module is located in the distributor, under the distributor cap.
According to my service manual, it should be on the passenger-side firewall, next to your fuel pump test connector. -Dave
Depending on the year. Early S10's up till 88 was located on the passenger side kick panel. The later ones are located behind the glove box.
If this is the 4.3 engine, it is located on the bracket next to the ignition coil.
The electronic control module (ECM) on a 1992 Chevy S10 4x4 pickup is typically located under the dashboard on the driver's side. It is mounted near the firewall, often attached to a bracket or the vehicle's frame. To access it, you may need to remove some panels or components for better visibility and reach. Be sure to disconnect the battery before working on the ECM to avoid any electrical issues.
It is bolted inside the distributor under the rotor on bass plate
if it is a new style s10 they had a common problem of the wiper control module going bad and intermittenly quiting. the module is located underneath the wiper motor cover.