answersLogoWhite

0

follow the wires back from the spark plug it usually goesm back to where the coil is

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What size engine is in a 5.2 liter 1995 firebird?

There was no 5.2 liter engine in a 1995 Firebird


What is the coolant capacity for a 1995 Chevrolet K1500 truck with a 5.7 liter engine?

20qt w/ AC 17.5qt w/o AC


How do you replace the ignition switch on 1995 F-350?

1995 ford 350 1 ton box truck ignition replacement


Where is the ignition coil located on a 1995 mercury grand marquis?

On a 1995 Mercury Grand Marquis with the 4.6 liter SOHC , V8 engine : It has the Electronic Distributorless Ignition System ( EDIS ) that has ( 2 ) coil packs ( each with 4 towers ) located near the front of the engine ( just follow the spark plug wires )


Where is the knock Sensor on a 1995 Mazda B4000 truck V-6 4.0?

I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )


Where is the knock Sensor on a 1995 Mazda B4000 truck V 6 4.0?

I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )


Where is the timing connector located on a 1995 Chevy truck with a 350 engine?

On a 1995 Chevy truck with a 350 engine, the timing connector is located near the distributor, typically on the driver's side of the engine. It's a single-wire connector that usually has a brown wire, and it's often found near the ignition module. To access it, you might need to move some wiring harnesses or components out of the way for better visibility. This connector is used to set the ignition timing by putting the engine into diagnostic mode.


What is the ignition timing for a 1995 2.3 liter Isuzu?

The ignition timing for a 1995 Isuzu with a 2.3-liter engine is typically set at around 10 degrees BTDC (before top dead center) at idle. However, it's important to consult the vehicle's service manual or a reliable source for the specific timing specs, as they can vary based on the engine's condition and any modifications. Always ensure that the engine is at the correct operating temperature and that the timing is checked with the appropriate tools for accuracy.


Is a 1995 2.0 liter engine in a dodge neon an interference engine?

Yes it is.


Why does the 1995 Ford 4 cylinder have two distributors?

From 1989 to 1997 the 2.3 liter four cylinder engine and from 1998 to 2001 the 2.5 liter four cylinder engine in the Ford Ranger used Fords twin plug ignition system with ( 2 ) sparkplugs per engine cylinder ( a total of 8 sparkplugs ) and had ( 2 ) coil packs used with the EDIS ( Electronic Distributorless Ignition System ) . It lowered the emissions of the engine


Valve setting's for 1995 Isuzu 138 cid 2.3 liter in a pup truck?

For the 1995 Isuzu 2.3-liter engine in the Pup truck, the valve clearance settings are typically 0.008 inches (0.20 mm) for both intake and exhaust valves when the engine is cold. It's important to check the specific service manual for your vehicle, as adjustments may vary slightly based on engine condition and specifications. Always ensure the engine is properly warmed up before performing any adjustments.


What size motor does my 1995 Ford Aerostar have?

A 1995 Ford Aerostar either has a 3.0 liter or a 4.0 liter V6 engine ( The 3.0L has the engine oil filter on the drivers side of the engine and the 4.0L it is on the passenger side of the engine )