Want this question answered?
the evap vent valve is located on the top of the fuel tank. the valve can only be serviced with the fuel tank removed from the vehicle. if you look under the rear of your vehicle in the trunk area you will see a black hose that looks like a household vacuum hose. that hose leads to the top of the to to the vent valve.
Follow the upper hose from your radiator back to the thermostat. The temp sensor is located right behind the thermostat on the back side of the engine.
mine is under the bed towards the back of the frame. its a black box with a hose going to a sensor, and another to your gas tank.
what part of the system? evap. blower motor in car. compressor dryer orfice hose assembly condensor under hood
Most likely the evap line, there is a fuel out, a fuel in ( recirculate ) and a vacuum ( evap ) line.
Its in the back of the suburban has a 2 wire connector and a air hose attached to it next to a box with two air hoses going to it
On the 2006 Chevy Impala, the thermostat is located in the hose that is directly above the middle cylinder. It is on the driver's side of the engine compartment right behind the alternator. Look for a long hose that goes from the radiator to that location.
It is located just beneath the lower radiator hose.
it is under the housing where the lower radiator hose hooks to the engine.it is under the housing where the lower radiator hose hooks to the engine.
3.7L and 4.7L it is under the housing where the lower radiator hose attaches to the engine. 5.7L it is under the housing where the upper radiator hose attaches to the engine.
It is under the housing where the upper radiator hose attaches to the engine.
Trouble P1486 means: EVAP Leak Monitor found a pinched hose