On the connector itself i don't remember which is ground, but i know that they number from top left to right then continues bottem left to right.
I think that you can use a body ground for a ground. If you are doing the flash test.
Possible causes are: Fuel Tank Pressure Sensor harness wiring is disconnected or shorted out. The Sensor may also be defective.
10 BTDC but you have to remember to ground the timing adjustment conector in the harness
amp by pass harness
If it is a 1996 or later.
The 1995 Dodge Intrepid does not have and ODB2 port, the Intrepids didn't introduce ODB2 until 1996.
This Harness Can't Ride Anything was created on 2006-10-10.
THE LIGHTER AND ODB2 USE THE SAME FUSE. CHECK TO SEE THAT THE FUSE IS NOT BLOWN.
Wyn Harness died on 2007-10-03.
plus and ground
P0121 Throttle/Pedal Position Sensor A Circuit Range/Performance IvryJade writes: Yes, but how do I fix it?
try www.installdr.com
On the left side of the driver just above the foot brake pedal about 2 inches inside the dash cover. It may have a black cover on it saying ODB2