In the boot under the carpet inside the spare wheel. Jack points are allocated under the arrows on the sill.
jack ther engine up, using a trolley jack, then take the engine mounting of, then you'l be able to get to the 3 bolts that holds your old alternator on, hope this helps
To remove the power steering rack from a Fiat Punto MK1, first, safely lift the vehicle and support it with jack stands. Disconnect the battery and remove the tie rod ends from the steering knuckles. Then, detach the steering column from the rack and disconnect the power steering hoses. Finally, unbolt the rack from its mounting points and carefully slide it out from the vehicle.
To change the back brakes on a 1994 Fiat Punto, first, lift the rear of the car using a jack and secure it with jack stands. Remove the wheel, then take off the brake caliper by unbolting it and slide it off the rotor. Replace the brake pads by removing the old ones and inserting new ones, making sure to compress the caliper piston if necessary. Reassemble by putting the caliper back in place, reinstalling the wheel, and lowering the car.
Under the seats
In the trunk, at the right side, next to the jack.
i have a 1997 1.6 8v punto. this is where it is on mine...... if you jack the car up and look close to the front, you should see the filter slightly to the drivers side on a angle.. It rides quite low down so jacking the car up would be the best option. i know its not v. informative but i cant think how else 2 explain it.
The latch release lever is on the driver's side on the floor next to the door. If the level is slack it points to a snapped bonnet release cable. To open the bonnet in this situation (on a Fiat Punto), you'll need to get under the car. Jack up the car, placed it on a stand on the passenger side, and reached up underneath. Watch the video: http://bit.ly/Yh1dQ9
The Jack is located underneath the rear bench seat on the drivers side. Open the rear side drivers door, and find the strap that removed the cusion, you will find the jack underneathe
the cluster nuts for the rear lights are located behind two plastic lugs located either side inside the back, there is one on top and one on the bottom you should have the plastic light removal tool with the jack that came with the car, remove the lugs with a screwdriver and you will see some plastic nuts, if you do not have the tool for them you can use a socket instead. once the two nuts are out unplug the wiring as you extract the light.
In a Fiat camper van, the jack is typically stored in a compartment within the vehicle, often located under the driver's seat, in the rear storage area, or in a designated panel in the cargo space. The exact location can vary by model, so it's advisable to refer to the owner's manual for specific details. Always ensure that the jack is easily accessible in case of a tire change or emergency.
In a 1995 Mazda Miata, the car jack is located in the trunk, specifically in a compartment on the driver's side. You can access it by lifting the carpet or cover in that area. Additionally, the jack is typically secured in place with a retaining strap or bracket. Make sure to check for any additional tools that may be stored alongside it.
It is in the trunk on the passenger side under a cover on the back corner where the jack is.