answersLogoWhite

0

your gay

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Location of the vacuum modulator valve on a 1992 Chevy 1500 pickup?

That year model did not have a modulator valve on the transmission.


Where is the vacuum modulator located on a 1999 Chrysler Sebring 2.5 jxi?

The transmission does not have a vacuum modulator.The transmission does not have a vacuum modulator.


Where is the vacuum modulator on a 2001 Pontiac Montana?

2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.


Where is the vacuum modulator on a 1999 Chrysler Sebring 2.5l?

The transmission on a Chrysler Sebring does not have a vacuum modulator.The transmission on a Chrysler Sebring does not have a vacuum modulator.


How do you find a transmission vacuum modulator for a 1991 Chrysler new yorker?

The transmission in a 1991 Chrysler does not have a vacuum modulator.The transmission in a 1991 Chrysler does not have a vacuum modulator.


What is a vacuum modulator?

On some of the older vehicles the vacuum modulator controlled the shift points of the transmission by using the vacuum supplied from the engine.


Where is the transmission modulator located for 91 cadillac sedan deville?

The transmission modulator on a 1991 Cadillac Sedan DeVille is typically located on the transmission itself, specifically on the side of the transmission case. It is usually positioned near the rear of the transmission, connected to the vacuum line from the engine. To access it, you may need to raise the vehicle and remove any obstructing components for better visibility. Always consult the vehicle's service manual for precise location and replacement procedures.


How do you adjust a vacuum modulator?

I assume your refering to the vacuum modulator which controls transmission shift points. Remove the vacuum hose from the modulator. Using a small screwdriver, turn the screw inside the modulator. It may take several tries to get it right.


What does a vacuum modulator do?

A vacuum modulator is used to apply pressure to the throttle valve. The modulator senses the pressure from the manifold and increases when the engine is under a heavier load.


Is there a seal at the end of the vacuum modulator?

There should be an o-ring where the modulator is inserted into the transmission. There should be no fluid where the vacuum line attaches, if so the modulator is bad.


Does the transmission have a modulator valve?

as far as I understand , it does not have a modulator. e4od are electronic. no vacuum shift modulator


Should the modulator valve have transmission fluid in it?

If a vacuum modulator has fluid in the vacuum port, it has failed and should be replaced.