answersLogoWhite

0

Where is oil sinding unit 88 chev 2.8 4wd located?

Updated: 9/17/2019
User Avatar

Wiki User

8y ago

Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is oil sinding unit 88 chev 2.8 4wd located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you disconnect the 4wd on the chev 2006 suburban?

no it will break


How do you remove front rotors from a 2004 Silverado crewcab not 4WD?

how do you remove front rotors from a chev 2004 silveraldo crewcab not 4wd


Which O2 sensor is bank 1 sensor 3 location for a 1997 chev S-10 V-6 4WD?

That would be the O2 sensor located after the catalytic converter.


How do you replace the wheel bearing assembly in a chev Tahoe with abs and 4wd?

how do you replace a wheel bearing assembly on the left side of a 2007 chevy tahoe with 4wd and abs brakes


How do I disable the transmission on my 1995 Chevrolet Blazer s-10 4wd so I can tow it?

How do I disable the transmission on myh 1995 chev blazer s-10 4wd so I can tow it?


Where is heater core located on 5.3 liter 2001 chev 1500?

The heater core is located on the passinger side under the dash board remove the cover screews and take it from there.Dave K. 1999 Silverado 1500 4WD 5.3 Vortex 8 owner


What kind of fluid should be used in a 89' chev 4wd 34 ton manual 5 spd tranny?

90 weight gear oil.


Where is the abs computer located on a 1996 Chevrolet Blazer 4WD?

on some it's the square metal box looking unit over passenger side fender wheel well


How do you get the green 4wd light stop flashing on your 98 Isuzu rodeo?

first check the 4wd transfer unit, it is located on the front axle on the drivers side. There should be two vacuum hoses one for 4wd the other for 2wd. There should be a vacuum on one but not the other, press the 4wd switch to see that they both work. If they are both working then you have to work on the transfer unit, here a hand operated vacuum pump ( some refer to it as a brake bleeder ) it might create enough of a vacuum to free the stuck transfer unit. I had to remove the unit and free the unit by hand ( hint I did have to use a screw driver to help pry mine loose ) once free operate it by hand several times to make sure it is loose, then replace it. After this I also found an air leak in the vacuum lines, I bypassed the vacuum line from the solidnoid to the transfer unit to find this problem.


Where is the Speed Sensor located on a 1999 Chevy Silverado Z71 4WD?

On the 1999 Chevy Silverado Z71 4WD, the speed sensor is part of a module. It is located next to the transmission housing.


Where is the speed sensor buffer in a 1992 Chev S-10 Blazer w 4.3L cpi and 4wd?

The speed sensor buffer is located behind the passenger side glove box. To access it remove the glove box and?æfind the white box which contains the chipset for the speedometer.?æ


How do I disable the transmission on my 1995 chev blazer s-10 4wd so I can tow it?

You will need to disconnect the driveshaft from the transmission. You will also need to disconnect the driveshaft from the rear end.