in exhaust pipes near cat. converters
how do you replace the overdrive sensor on a 94 ford explorer
Where are the Bank 1 Sensor 1 oxygen sensor on a 1998 ford explorer?
yes
where is the oxygen sensor location on a 1998 explorer bank 2 sensor
No , as far as I know not until the 1996 Explorer with the OBD II / EEC V
To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.
Just unplug the electrical connector and then unscrew the oxygen sensor out of the exhaust pipe.
M14x1.5
The oxygen sensor(s) before the catalytic converter(s) is used to determine the air / fuel ratio of the engine
It is located on the header.
It is screwed into the exhaust, behind the engine.
The crankshaft position sensor is located on the front of the engine. It is just to the left of the crankshaft pulley.