0
REar side of radiator approx. 1/3 from the top
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How to replace a Power window switch on a 1993 Buick Skylark?
Do you mean the main switch by the driver or the switch on the door itself?
1993 Buick Skylark?
won't idle
How do you replace the alternator on a 1993 Buick Skylark?
you replace it by...hold on
What are some possible problems on a 1993 Buick Skylark 3300 that can allow the engine to rotate but not start and no trouble codes?
I took it to a shop. It was the crankshaft position sensor.
Where is the horn located in a 1993 Buick Skylark custom?
on the steering wheel
Replace ignition switch for 1993 Buick century?
Replace ignition switch for 1993 buick century?
How much does a 1993 Buick Skylark weigh?
It's around 2800 pounds.
Where is the fuel pump reset button located on a 1993 Buick Skylark?
Does not have one.
What is the size of the 1993 Buick skylark's speakers in the front door?
4x6 hard to replace!!!
About how much does it cost to repair the head gasket on a 1993 Buick Skylark?
I have a 1995 Skylark and that repair is at least $500.00 but it's worth it. The engine runs great now.
What does the neutral safety switch look like and were is it located on a 1993 Buick lesabra?
what dose the neutral safety switch look like and were is it located on a 1993 buick lesabra at
Will an engine out of a 1993 Buick Skylark 3.3 engine fit into a 1994 Buick Skylark 3.8 engine without any problems?
It will physically bolt in--HOWEVER--the 3.8 uses a separate cam position sensor while the 3.3 incorporates it into a single sensor unit with the crank position sensor, so the wiring harness is different. Also--the computer calibration is different owing to the difference in displacement. Unless a donor car is available with the correct wiring and ECM/ECU and one has the knowledge to do this--it is NOT recommended.
